Ethanol blends cut marine fuel emissions by up to 31%
The highest tested blend replaced 60% of diesel by volume.
The Global Centre for Green Fuels (GCGF) and Nanyang Technological University, Singapore (NTU Singapore) have demonstrated that ethanol-biodiesel-diesel blends can run successfully in a pilot-scale marine diesel engine, according to interim findings from a joint feasibility study.
It also found the blends reduced lifecycle greenhouse gas (GHG) emissions by up to 31%.
The study, conducted with NTU Singapore's Maritime Energy and Sustainable Development Centre of Excellence (MESD), evaluates ethanol against five other alternative marine fuels and tests blends designed for conventional marine engines.
The highest blend tested, E30B30D40, replaces 60% of conventional diesel with renewable ethanol and biodiesel by volume, or 53% on an energy basis.
Its lifecycle GHG emissions intensity is estimated at 64.91 to 67.90 grams of carbon dioxide equivalent per megajoule (gCO₂eq/MJ), representing a 28% to 31% reduction compared with the 94 gCO₂eq/MJ baseline for conventional fossil diesel.
The trials used a four-stroke marine diesel engine of harbour-craft size, with technical support from the Seatrium New Energy Laboratory at NTU's School of Mechanical and Aerospace Engineering.
Researchers tested three formulations: E10B10D80, E20B20D60, and E30B30D40. All ran reliably during pilot engine operations.
Whilst ethanol does not form a stable blend with diesel on its own, researchers found that biodiesel acts as a co-solvent, producing stable, single-phase fuel blends.
A one-to-one ethanol-to-biodiesel ratio maintained stability at the highest ethanol content tested, whilst lower ratios are being investigated.
The blends are not yet drop-in fuels under current rules, with their flash points and fuel-system requirements still under assessment.
Estimated brake thermal efficiency was maintained or slightly improved across all test points, rising by up to 0.73 percentage points for E30.
However, maximum engine power output fell by up to 12.9%, reflecting ethanol's lower energy density compared with fossil diesel.
All three blends reduced carbon monoxide emissions, with E30 achieving cuts of up to 43%.
E10 and E20 also reduced nitrogen oxides emissions at matched-power test points, whilst E30 results varied with engine load. The blends also moderated the nitrogen oxides increase typically observed with pure biodiesel.
The interim report also compared ethanol with methanol, fatty acid methyl ester biodiesel, liquefied natural gas, ammonia, and hydrogen across production readiness, operational safety, and commercial costs.
Ethanol scored nine out of nine for production readiness, supported by established manufacturing and distribution infrastructure.
Global production reached approximately 118.5 billion litres in 2024, equivalent to 61.9 million tonnes of very low sulphur fuel oil (VLSFO) in energy terms, and is projected to reach 80.9 million tonnes of VLSFO equivalent by 2033.
It scored eight out of nine for operational safety. Although less acutely toxic than methanol and liquid under ambient conditions, ethanol's low flash point requires dedicated ignition controls, vapour management systems and material compatibility protocols on board vessels.
Ethanol was assessed at $1,233 (US$956) to $1,872 (US$1,451) per VLSFO-equivalent tonne, overlapping the study's VLSFO price benchmark.
At the midpoint, it is approximately 42% more expensive than fossil fuel oil and requires 1.9 cubic metres of bunker storage space per tonne of VLSFO energy equivalent.
GCGF and NTU MESD will present the interim findings at the IBIA Alternative Marine Energy Forum during Hong Kong Maritime Week on 19 November.
The study's second phase will involve expanded engine testing and durability assessments, with the final report scheduled for publication in 2027.
(US$1 = SG$1.29)